Hot Deal 4 Fader 4 Knob 4 Button Usb And Din Midi Controller - Limited Release [Jq9t6luE]

USB and Din MIDI Controller custom with 4 Faders 4 knob 4 buttons. 
Detachable Type-C USB connection
(2m Type-C to Type-A cable included).

Box dimensions are 170mm x 120mm x 35mm

The fader travel is 60mm.

The knobs are potentiometers and are the version that stop
(only turn 270 degrees 7 to 5 o’clock)

Each button can be individually programmed when pressed to send either control change messages (1 to 127), program change messages (1 to 127) or MIDI note on /off message notes (1 to 127).

when a button is pressed the display will show the button message value 1 to 127.
The buttons can be set to Toggle or Momentary mode

The faders/knobs when moved send control change messages and the display shows the output value.

The MIDI channel of the controller can be set from 1 to 16 or each fader and buttons can each be set individually to different channels

All changes are done using the display and small button located on the USB side of the box no extra software is needed

The faders, Knobs and buttons can be MIDI learn/mapped in your DAW software or used with hardware that responds to control change messages and program change commands

The Program change value is 0 to 127 some devices see this as 1 to 128
The control change ON value is 0 and the OFF value is 127

Each Fader/knob can also be set to a different channel allowing control of multiple devices,

The controller can use both USB and DIN MIDI at the same time allowing you to control DAW software with a fader/knob and a hardware device with another.

The USB Cable is also needed to power the unit when only using the DIN socket and needs to be plugged into a USB port/power hub or plug socket (phone charger plug).

The controller Can be used to control Ableton Live and other DAW software that allows MIDI learn/mapping, and also most device that uses MIDI CC's

(please refer to the manual of your device for the CC numbers).

will not work with VirtualDJ

Instructions on how to program the controller are below.