Dorm Essential Stick It Anchor Pins Motor Mount Bracket System With 10' Tube Connector Anchor Pin Set [0zDHOhtT]

Included:  

10' total length 2 piece Stick It Anchor Pin® with Stainless Steel Epoxy Tube Connector 

(1 x 3' anchor pin with a T-handle on one end and stainless steel tube connector on the other end and 1 x 7' anchor pin with a  grounded point on one end - to be joined together with epoxy to become a permanent one piece anchor pin)

1 x 0.47 oz 2 part Epoxy

2 x Mounting clips

2 x Stainless steel screws

2 x Velcro rough water safety straps

Aluminum motor mount bracket for starboard or port side in black or white

Impact cushion

Rubber grommet

This system is used when a customer requires a 10 foot, one-piece Stick It Anchor Pin®  that may not be available at a local dealer.  We do offer a one-piece 10 foot anchor pin, however shipping charges for items over 8 feet long exceed $300 via freight.  We have designed a durable solution to this problem by offering a 10' x ¾” reinforced polyester resin Stick It Anchor Pin® connected with a Stainless Steel epoxy-together tube to form a permanent one piece anchor pin.  We provide you with one end of the Stick It Anchor Pin® with the stainless steel tube attached.  When you receive your order you will attach the other 7 foot end of the Stick It Anchor Pin®  with the epoxy we provide you. Allow it to set overnight and you have a durable and long one piece Stick It Anchor Pin® without having to pay exorbitant shipping prices.  

The Stick It Anchor Pins® Motor Mount Bracket is a ⅜” thick aluminum mounting bracket that attaches where your motor meets the transom. It mounts directly on top of your outboard motor’s mounting bracket.  

It’s recommended for flats boats/bass boats up to 20ft and bay boats up to 19ft and with 200hp engines or less. Motor Mount will fit engine bolt spacing of 7-1/4” to 8-1/2” inches apart.  

Be sure to check for clearance of trim tabs, trailer tie downs, eye cleats, poling platforms, or any other object mounted near your transom wall. It can be used with some jack plates, but when moving the jack plate, clearance can be an issue.   

Installation is easy. Loosen the upper motor mount nut and place the Stick It Anchor Pins® Motor Mount onto it and hand tighten.  Then loosen the lower nut and slip the Motor Mount hole over that bolt.  Tighten both nuts and that's it! It’s just that easy.