Check Out Push Valve 60/40 Snap-on Outlet All Sizes Available [kIydz6x3]

Reduce Your Helium Costs by up to 40%!

The Helium/Air Outlet snaps on to Conwin’s 10ft Extension Hose Inflators and enables you to inflate 11” and larger latex balloons with a mixture of 60% helium and 40% air. Investment is quickly recovered with helium savings. By covering air intakes, outlet will also inflate balloons with 100% helium. 10ft Extension Hose Inflator not included.

Inflate Latex Balloons with a 60/40 Mixture of Helium and Air
The Fast-Flow Push Valve has a tapered tip to easily fit 11″ and larger latex balloons. Place the balloon over the latex outlet and press downward until balloon has reached desired size. The two holes located on either side of the outlet allow the air to be drawn in as the helium passes upward and into the balloon.

Helium/Air Outlet Also Inflates Balloons with 100% Helium
By covering the air intakes, the 60/40 Helium/Air Outlet will also inflate balloons with 100% helium. Cover the air intakes with tape for prolonged use with 100% helium.

Quickly Change From one Snap-On Outlet to the Next
To remove the outlet, slide the brass sleeve on the quick disconnect fitting.

Latex Balloon Size                          Approx. Float Time 

11″ Latex w/ No Hi-Float                  8-12 Hours

11″ Latex w/ Ultra Hi-Float*             3-10 Days

16″ Latex                                          30+ Hours

24″ Latex                                          2-4 Days

30″ & 3ft Latex                                3-5 Days

Note: Float times may vary due to altitude, environmental conditions, and proper balloon sizing.

* For maximum float time on 11″ balloons with a 60/40 mix, it is recommended to use Ultra Hi-Float with the purple restriction clip on the Hi-Float pump.

  Instruction sheet